Collider 60 kit
Kit contents shown (LEDs not in photo, but are included in the kit)
- See Collider 60 Introduction
Collider 60 is an easy to assemble kit suitable for beginners. Relatively small number of parts are spaced apart enough so that the soldering is simple.
Please note that Collider 60 is designed to be connectable. Unlimited number of units can be snapped together like tiles, in four directions.
Features/Notes:
- 60 white diffused 5mm LEDs
- PIC microcontroller is preprogrammed
- PIC24F08KL402 16 bit microcontroller @ 32 MHz
- Dimension: 4.72 inch (120mm) square, excluding the connector protruding
- Snappable connector to tile multiple units
- Unlimited number of connected units
Each Kit Contains:
- 60x white diffused 5mm LEDs
- 1x PIC24F08KL402 16 bit microcontroller
- 1x 10k ohm Resistor (Brown, Black, Orange, Gold)
- 6x 1k ohm Resistor (Brown, Black, Red, Gold)
- 3x 0.1 uF Ceramic Capacitor
- 1x 47 uF Electrolytic Capacitor
- 1x 1N4148 or equivalent Switching Diode
- 1x Tactile Switch
- 1x Piezoelectric Speaker
- 1x 20k ohm Potentiometer
- 2x Molex Female header (3 position)
- 2x Molex Male header (3 position)
- 1x Knob
- 1x PCB
[Download]
- Circuit Schematics
- Assembly Guide
Follow
I purchased a Collider 60 kit at the Bay Area Maker Faire, and I’ve finally gotten around to putting it together. (Only one, though.) (
The video mentions that various parameters are “easily configurable”, and I found the config mode behind the usual “long button press.” But I can’t figure out what any of the parameters ARE, and I can’t find any documentation…
September 16, 2014 at 4:30 am